CLI Reference Guide Redundancy Configuration Commands
Redundancy Configuration Commands
auto-sync
Use this command to synchronize runing-config and startup-config in the case of redundancy of dual supervisor
engines. Use the no form of this command to disable the function.
auto-sync { standard | running-config | startup-config}
no auto-sync { standard | running-config | startup-config}
Synchronize all the system files.
Synchronize the runtime configuration files.
Synchronize the startup configuration files.
All the files are synchronized by default.
Redundancy configuration mode.
Generally the standard synchronization should be used if there is no
special requirement.
The following example only synchronizes the startup-config files
Ruijie(config)# redundancy
Ruijie(config-red)# auto-sync startup-config
Ruijie(config-red)# exit
The following example synchronizes all the files other than the
starup-config files.
Ruijie(config)# redundancy
Ruijie(config-red)# no auto-sync startup-config
Ruijie(config-red)# exit
auto-sync time-period
Use this command to configure the auto-sync time-period of runing-config and startup-config when the dual
supervisor engines is redundant. Use the no form of this command to disable the function.
auto-sync time-period value
To Next Page
Loading...
Need help?
General