Ruijie RG-S2600G-I Series - Page 200

CLI ReferenceInterface Configuration Commands MAC Address Configuration Commands
mac-address-table notification
Use this command to enable the MAC address notification function. You can use The no form of the
command to disable this function.
mac-address-table notification [interval value | history-size value]
no mac-address-table notification [interval | history-size]
Parameter
description
Parameter
Description
interval value
Specify the interval of sending the
MAC address trap message, 1
second by default.
history-size value
Specify the maximum number of the
entries in the MAC address
notification table, 50 entries by
default.
Default
configuration
By default, the interval is 1 and the maximum number of the entries in
the MAC address notification table is 50.
Command
mode
Global configuration mode.
Usage
guidelines
The MAC address notification function is specific for only dynamic
MAC address and secure MAC address. No MAC address trap
message is generated for static MAC addresses. In the global
configuration mode, you can use the snmp-server enable traps
mac-notification command to enable or disable the switch to send
the MAC address trap message.
Examples
Ruijie(config)# mac-address-table notification
Ruijie(config)# mac-address-table notification interval 40
Ruijie(config)# mac-address-table notification history-size 100
Related
commands
Command
Description
snmp-server enable
traps
Set the method of handling
the MAC address trap
message..
show
mac-address-table
notification
Show the MAC address
notification configuration and
the MAC address trap
notification table.