Ruijie RG-S2600G-I Series - Page 199

CLI ReferenceInterface Configuration Commands MAC Address Configuration Commands
mac-address-table filtering
Use this command to configure the filtering MAC address. Use the no form of the command to remove
the filtering address.
mac-address-table filtering mac-address vlan vlan-id [source | destination]
no mac-address-table filtering mac-address vlan vlan-id
Parameter
description
Parameter
Description
mac-address
Filtering Address
vlan vlan-id
VLAN ID. Its range depends on
the switch.
source
Filter the frame according to
the source MAC address only.
destination
Filter the frame according to
the destination MAC address
only.
Default
configuration
No filtering address is configured by default.
When configuring this command without the source or destination
specified, the frame received in the specified VLAN, which has the
same source/destination MAC address with the specified MAC
address, will be filtered.
Command
mode
Global configuration mode.
Usage
guidelines
The filtering MAC address shall not be a multicast address. Use
show mac-address-table filtering to display the filtering MAC
addresses.
Examples
Ruijie(config)# mac-address-table filtering 00d0f8000000 vlan 1
Related
commands
Command
Description
clear
mac-address-table
filtering
Clear the filtering MAC
address.
show
mac-address-table
filtering
Show the filtering MAC
address.