CLI ReferenceInterface Configuration Commands MAC Address Configuration Commands
Maximum Number of entries configured in History Table:1
Current History Table Length: 0
Ruijie# show mac-address-table notification history
History Index: 0
MAC Changed Message:
Operation:ADD Vlan: 1 MAC Addr: 00f8.d012.3456 GigabitEthernet 3/1
mac-address-table
notification
Enable MAC address
notification.
snmp trap
mac-notification
Enable the MAC address
trap notification function on
the specified interface.
show mac-address-table static
Use this command to show the static MAC address.
show mac-address-table static [addr mac-addr] [interface interface-id] [vlan vlan-id ]
Destination MAC address of the entry
Interface of the entry (physical
interface or aggregate port)
Show only static MAC addresses
Ruijie# show mac-address-table static
Vlan MAC Address Type Interface
---------- -------------------- -------- ---------
1 00d0.f800.1001 STATIC gigabitethernet 1/1
1 00d0.f800.1002 STATIC gigabitethernet 1/1
1 00d0.f800.1003 STATIC gigabitethernet 1/1
Configure the static MAC address.
clear
mac-address-table
static
Clear the static MAC address.