CLI ReferenceInterface Configuration Commands Aggregate Port Configuration Commands
Aggregate Port Configuration Commands
aggregateport load-balance
Use this command to configure the load-balancing algorithm for an aggregate port (AP). Use the no
form of this command to restore the default load-balancing configuration.
aggregateport load-balance { dst-mac | src-mac | src-dst-mac | dst-ip | src-ip | src-dst-ip |
src-port | src--dst-ip-l4port }
no aggregateport load-balance
Traffic is distributed according to the destination MAC addresses of the incoming
packets. For all the links of an aggregate port, the packets with the same
destination MAC addresses are sent to the same port, and those with different
destination MAC addresses are sent to different ports.
Traffic is distributed according to the source MAC addresses of the incoming
packets. For all the links of an aggregate port, the packets with different
addresses are distributed to different ports, and those from the same addresses
are distributed to the same port.
Traffic is distributed according to the source IP address and destination IP
address. Packets with different source and destination IP address pairs are
forwarded through different ports. The packets with the same source and
destination IP address pairs are forwarded through the same links. At layer 3, this
load balancing style is recommended.
Traffic is distributed according to the destination IP addresses of the incoming
packets. For all the links of an aggregate port, the packets with the same
destination IP addresses are sent to the same port, and those with different
destination IP addresses are sent to different ports.
Traffic is distributed according to the source IP addresses of the incoming
packets. For all the links of an aggregate port, the packets with different
addresses are distributed to different ports, and those with the same addresses
are distributed to the same port.
Traffic is distributed according to the source and destination MAC addresses.
Packets with different source and destination MAC address pairs are forwarded
through different ports. The packets with the same source and destination MAC
address pairs are forwarded through the same port.
Traffic is distributed according to the source port of the incoming packets.
Packets with different source ports are forwarded through different ports, and the
incoming packets with the same source port are load-balanced to the same
outgoing port. If the source port is an AP member port, use the AP-ID to
implement load-balancing. This means that packets with the same AP member
To Next Page
Loading...
