CLI ReferenceInterface Configuration Commands Aggregate Port Configuration Commands
port will be load-balanced to the same outgoing port.
Traffic is distributed according to the source IP, destination IP, source L4 port and
destination L4 port. Packets with different source IP addresses, destination IP
addresses, source L4 ports and destination L4 ports are forwarded through
different ports, and packets with the same source IP address, destination IP
address, source L4 port and destination L4 port are forwarded through the same
port.
Traffic is distributed according to the destination and source MAC addresses of the incoming packets.
Global configuration mode.
Use show aggregateport load-balance command to display load-balancing algorithm configuration.
Configure the MAC address-based load-balancing.
Ruijie(config)# aggregateport load-balance dst-mac
show aggregateport load-balance
Use this command to display aggregateport
configurations.
Use this command to assign a physical interface as a member port of an aggregate port. Use the no
form of the command to remove the membership from the aggregate port.
port-group port-group-number
Number of the member group of an aggregate port that is the
interface number of the aggregate port.
By default, the physical port does not belong to any aggregate port.
Interface configuration mode
All the members of an aggregate port belong to a VLAN or configured to be trunk ports. The ports
belonging to different native VLANs cannot form an aggregate port.
To Next Page
Loading...
