Ruijie RG-S2600G-I Series - Page 216

CLI ReferenceInterface Configuration Commands Aggregate Port Configuration Commands
Configuration
Examples
This example shows how to specify the Ethernet interface 1/3 and 1/4 as members of AP 3:
Ruijie(config)# interface gigabitethernet 1/3
Ruijie(config-if)# port-group 3
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
show aggregateport
Use this command to display the aggregate port configurations.
show aggregateport aggregate-port-number [ load-balance | summary ]
Parameter
Description
Parameter
Description
aggregate-port-number
Interface number of the aggregate port.
load-balance
Show the load-balance algorithm on the aggregate port.
summary
Show the summary of the aggregate port.
Defaults
N/A
Command
Mode
Any command modes.
Usage Guide
Information of all aggregate ports will be displayed unless you specify an interface number of the
aggregate port.
Configuration
Examples
See the configuration information of Aggregate Port 1.
Ruijie# show aggregateport 1 summary
AggregatePort MaxPorts SwitchPort Mode Ports
-----------------------------------------------------------------------
Ag1 8 Enabled ACCESS
Related
Commands
Command
Description
aggregateport load-balance
Configure a load-balancing algorithm for an AP.
Platform
Description
N/A