CLI ReferenceInterface Configuration Commands LACP Configuration Commands
lacp port-priority
Use this command to set the LACP port priority. Use the no form of this command to
return to the default value.
lacp port-priority port-priority
no lacp port-priority
When multiple ports are to be aggregated, the ports with high
priorities take precedence and the port with the highest priority is
selected as the master port. The port priority sequence is determined
according to the wire quality.
The LACP cannot be enabled on the ports with the function of
forbidding the member ports to add to or leave the AP enabled; and
the function of forbidding the member ports to add to or leave the AP
cannot be enabled on the LACP member ports. The AP with the
function of forbidding the member ports to add to or leave cannot
configured as the LACP AP, and function of forbidding the member
ports to add to or leave the AP cannot be enabled on the LACP AP.
The SYSLOG will be displayed when the LACP fails to leave the AP
due to external function limitations, such
as: %LACP-5-UNBUNDLE_FAIL: Interface FastEthernet 0/1 failed to
leave the AggregatePort 1. In this case, please modify the
configuration to cancel the related configuration of forbidding the
member ports to leave the AP, otherwise the normal packets
transmission on the AP will be influenced.
To Next Page
Loading...
Need help?
General