CLI ReferenceInterface Configuration Commands LACP Configuration Commands
port-group key mode{active
| passive}
Enable the LACP on the port and
specify the aggregation group ID
and operation mode.
lacp system-priority
Use this command to set the LACP system priority. The no form of it restores it to the default.
lacp system-priority system-priority
no lacp system-priority
The LACP system priority, in
the range of 0-65535.
By default, the system priority is 32768.
Global configuration mode.
LACP system priority consists of the Layer2 management MAC
address and its priority value, where the MAC address is fixed but the
priority value is configurable. If two priorities are equal, then the
smaller the MAC address is, the higher the priority is. All LACP
groups on the switch share the system priority. Changing the system
priority may influence the whole aggregation groups on the switch.
Ruijie(config)# lacp system-priority 4096
port-group key
mode{active | passive}
Enable the LACP on the port
and specify the aggregation
group ID and operation
mode.
Set the LACP port priority.
To Next Page
Loading...
Need help?
General