CLI ReferenceInterface Configuration Commands LACP Configuration Commands
Showing Related Command
show lacp summary
Use this command to show the LACP aggregation information.
show lacp summary [key]
Specify the aggregation group id to
show. If it is not specified, all
aggregation group information is shown
by default.
Ruijie# show LACP summary
Flags:S - Device is sending Slow LACPDUs F - Device is sending fast
LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Aggregate port 3:
Local information:
LACP port Oper Port Port
Port Flags State Priority Key Number State
-------------------------------------------------------------
Gi0/1 SA bndl 4096 0x3 0x1 0x3d
Gi0/2 SA bndl 4096 0x3 0x2 0x3d
Gi0/3 SA bndl 4096 0x3 0x3 0x3d
Partner information:
LACP port Oper Port Port
Port Flags Priority Dev ID Key Number State
------------------------------------------------------------
Gi0/1 SA 61440 00d0.f800.0002 0x3 0x1 0x3d
Gi0/2 SA 61440 00d0.f800.0002 0x3 0x2 0x3d
Gi0/3 SA 61440 00d0.f800.0002 0x3 0x3 0x3d