Ruijie RG-S2600G-I Series - Page 248

CLI ReferenceInterface Configuration Commands Voice VLAN Configuration Commands
the Voice VLAN, or the port not used for a long time can
be still in the Voice VLAN.
 Note
1. With the Voice VLAN enabled on the port, the auto
and manual modes switchover is disallowed. Disable the
Voice VLAN first if it is necessary to switch the modes.
2. In the auto mode, it fails to add/remove the port
to/from the Voice Vlan by using the command.
Examples
The following example shows how to set the Voice VLAN on the
interface FastEthernet 0/1 work in the auto mode:
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-vlan)# voice vlan mode auto
Related
commands
Command
Description
show voice vlan
Show Voice VLAN configurations
and the current state.
voice vlan security enable
Use this command to enable the Voice VLAN security mode in the global configuration mode. Use the
no form of this command to disable the security mode.
voice vlan security enable
no voice vlan security enable
Parameter
description
Parameter
Description
-
-
Default
Settings
Enabled
Command
mode
Global configuration mode.
Usage
guidelines
The Voice VLAN working mode can be classified into the
auto-mode and the manual-mode, and configured on the
port. The working modes for the Voice VLAN on each port
are independent, and different ports can work in different
working modes. In different working modes, the methods
of enabling the Voice VLAN function on the port are
different. The working mode can be set according to the IP