Ruijie RG-S2600G-I Series - Page 247

CLI ReferenceInterface Configuration Commands Voice VLAN Configuration Commands
Related
commands
Command
Description
show voice vlan
oui
Show the OUI address, OUI
address mask and the
descriptions.
voice vlan mode auto
Use this command to set the Voice VLAN auto mode in the interface configuration mode. Use the no
form of this command to cancel the Voice VLAN auto mode.
voice vlan mode auto
no voice vlan mode auto
Parameter
description
Parameter
Description
-
-
Default
Settings
Auto mode.
Command
mode
Interface configuration mode.
Usage
guidelines
The Voice VLAN working mode can be classified into the
auto-mode and the manual-mode, and configured on the
port. The working modes for the Voice VLAN on each port
are independent, and different ports can work in different
working modes. In different working modes, the methods
of enabling the Voice VLAN function on the port are
different. The working mode can be set according to the IP
phone type connected downward the port or the port type.
 Caution
1. With the Voice VLAN enabled on the port and in the
manual mode, this port must be added to the Voice VLAN
manually to ensure the function validity.
2. When the port works in the auto-mode, note that the
native VLAN of the port cannot be set as the Voice VLAN
for the normal function performance.
3. The Trunk Port/Hybrid Port on the Ruijie product can
transmit the packets in all VLANs by default. First remove
the Voice VLAN from the allowed VLAN list for the port,
then enable the Voice VLAN to ensure that the port
disconnecting with the voice device cannot be added to