CLI ReferenceInterface Configuration Commands MSTP Configuration Commands
Show the status of BPDU filter.
Show the status of portfast.
Show the status of BPDU guard.
Show the link type of an interface.
Ruijie# show spanning-tree interface gigabitethernet 1/5
Enable the BPDU filter feature on an interface.
Enable the portfast on an interface.
Enable the BPDU guard on an interface.
Set the link type of an interface to point-to-point.
show spanning-tree mst
This command is used to display the configuration of MST and the information about instances
in privileged EXEC mode.
show spanning-tree mst { configuration | instance-id [ interface interface-id ] }
The MST configuration of the device.
All the instances are displayed by default.
Ruijie# show spanning-tree mst configuration
To Next Page
Loading...
Need help?
General