CLI ReferenceInterface Configuration Commands MSTP Configuration Commands
spanning-tree tx-hold-count STP
Set the global TxHoldCount of STP.
spanning-tree autoedge
This command is used to enable Autoedge on an interface. You can use the disabled option of
this command to disable Autoedge on the interface.
spanning-tree autoedge [ disabled ]
Disable the Autoedge of an interface.
Interface configuration mode
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# spanning-tree autoedge disabled
show spanning-tree interface
Show the STP configuration information of an
interface.
spanning-tree bpdufilter
This command is used to enable the BPDU filter function on an interface. You can use the
enabled or disabled option of the command to enable or disable the BPDU filter function on
the interface.
spanning-tree bpduguard [enabled | disabled]
Enable the BPDU filter on an interface.
Disable the BPDU filter on an interface.
To Next Page
Loading...
Need help?
General