CLI ReferenceInterface Configuration Commands GVRP Configuration Commands
gvrp registration mode
Use this command to set the registration mode to control whether to allow
creating/registering/canceling the vlan dynamically on the port. Use the no form of this
command to restore it to the default setting.
gvrp registration mode {normal | disabled}
no gvrp registration mode
Creating/registering/canceling the vlan dynamically is allowed.
Interface configuration mode.
Use the show gvrp configuration to show the related
configurations.
Ruijie(config-if)# gvrp registration mode normal
Show the GVRP configurations.
gvrp timer
Use this command to set the GVRP timer. Use the no form of this command to restore it to
the default setting.
gvrp timer {join | leave | leaveall} timer_value
no gvrp timer
Control the maximum delay before
sending the advertisement on the port.
The actual sending interval is in the
range of 0 to the maximum delay.
Control the waiting time before removing
the VLAN from the port with the Leave
Message received. If the Join Message
is received again within this time range,
the port-VLAN relation is still exist and
the timer becomes invalid. If no Join
To Next Page
Loading...
Need help?
General