CLI ReferenceInterface Configuration Commands GVRP Configuration Commands
Message is received on the port, the port
status will be the Empty and removed
from the VLAN member list.
Control the minimum interval of sending
the LeaveAll Message on the port. If the
LeaveAll Message is received before the
timer expires, the timer re-counts. If the
timer expires, send the LeaveAll
Message on the port and also send this
Message to the port, so that the Leave
timer begins counting. The actual
sending interval is ranging from leaveall
to leaveall+join.
Join timer: 200ms;
Leave timer: 600ms;
Leaveall timer: 10000ms.
Global configuration mode.
Use the show gvrp configuration to show the related
configurations.
Ruijie(config)# gvrp timer join 200
Show the GVRP configurations.
Showing Related Commands
clear gvrp statistic
Use this command to clear the GVRP statistics for re-counting.
clear gvrp statistics { interface-id | all}
To Next Page
Loading...
Need help?
General