Ruijie RG-S2600G-I Series User Manual

CLI ReferenceInterface Configuration Commands LLDP Configuration Commands
Parameter
description
Parameter
Description
profile-num
ID of the LLDP network-policy. Range: 1-1024.
Default
-
Command
mode
Global configuration mode
Usage
guidelines
Use this command to enter the LLDP network-policy configuration mode. Specify a policy ID before
using this command.
After entering the LLDP network-policy configuration mode, run the { voice | voice-signaling } vlan
command to configure a specific network policy.
Examples
Create an LLDP network-policy. ID: 1
Ruijie#config
Ruijie(config)#lldp network-policy profile 1
Ruijie(config-lldp-network-policy)#
Related
commands
Command
Description
show lldp network-policy profile [ profile-num ]
Show the LLDP network policy.
Platform
description
Only supported by switch products.
lldp notification remote-change enable
Configure LLDP Trap. Use no form of this command to disable LLDP Trap.
lldp notification remote-change enable
no lldp notification remote-change enable
Parameter
description
Parameter
Description
-
-
Default
Disabled
Command
mode
Interface configuration mode.
Usage
guidelines
By configuring LLDP Trap, the LLDP information of local device (such as information about the
detection of new neighbor or the fault on the communication link) can be sent to the network

Ruijie RG-S2600G-I Series Specifications

General

Brand	Ruijie
Model	RG-S2600G-I Series
Category	Switch
Language	English