Ruijie RG-S2600G-I Series User Manual

CLI ReferenceInterface Configuration Commands LLDP Configuration Commands
management server. The administrator can monitor the network operation status according to such
information.
Examples
Configure LLDP Trap:
Ruijie# configure terminal
Ruijie(config)#interface gigabitethernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)#lldp notification remote-change enable
Related
commands
Command
Description
show lldp status
Display LLDP status information.
Platform
description
Only supported by switch products.
lldp timer notification-interval
Configure an interval of sending LLDP Traps. Use no form of this command to restore to the default
interval.
lldp timer notification-interval seconds
no lldp timer notification-interval
Parameter
description
Parameter
Description
seconds
Configure the interval of sending LLDP Traps. Default: 5 seconds; configurable range:
5-3600 seconds.
Default
5 seconds
Command
mode
Global configuration mode.
Usage
guidelines
To prevent excessive LLDP traps from being sent, you can set an interval of sending LLDP Traps. If
LLDP information change is detected during this interval, traps will be sent to the network management
server.
Examples
Configure the interval of sending LLDP Traps to 10 seconds:
Ruijie# configure terminal
Ruijie(config)#lldp timer notification-interval 10
Related
commands
Command
Description
show lldp status
Display LLDP status information.

Ruijie RG-S2600G-I Series Specifications

General

Brand	Ruijie
Model	RG-S2600G-I Series
Category	Switch
Language	English