CLI ReferenceInterface Configuration Commands LLDP Configuration Commands
Only supported by switch products.
Configure port initialization delay. Use no form of this command to restore the port initialization delay to
the default setting.
lldp timer reinit-delay seconds
no lldp timer reinit-delay
Port initialization delay. Configurable range: 1-10 seconds.
Global configuration mode.
To prevent LLDP from being initialized too frequently due to the frequent operating mode change, you
can configure port initialization delay.
Configure LLDP port initialization delay to 3 seconds:
Ruijie# configure terminal
Ruijie(config)#lldp timer reinit-delay 3
Display LLDP status information.
Only supported by switch products.
Configure LLDP packet transmission delay. Use no form of this command to restore the transmission
delay to the default setting.
lldp timer tx-delay seconds
To Next Page
Loading...
Need help?
General