CLI ReferenceInterface Configuration Commands LLDP Configuration Commands
Ruijie# configure terminal
Ruijie(config)#lldp timer tx-interval 10
Display LLDP status information.
Only supported by switch products.
Configure the types of advertisable TLVs. Use no form of this command to cancel the advertising of
specific TLV types.
lldp tlv-enable {basic-tlv { all | port-description | system-capability | system-description |
system-name } |dot1-tlv { all | port-vlan-id | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] }
|dot3-tlv { all | link-aggregation | mac-physic | max-frame-size | power } | med-tlv { all | capability |
inventory | location { civic-location | elin } identifier id | network-policy profile [ profile-num ] |
power-over-ethernet } }
no lldp tlv-enable {basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id | vlan-name } | dot3-tlv { all |
link-aggregation | mac-physic | max-frame-size | power } | med-tlv { all | capability | inventory |
location { civic-location | elin } identifier id | network-policy profile [ profile-num ] |
power-over-ethernet } }
802.1 organizationally specific TLV
Port And Protocol VLAN ID TLV
VLAN ID corresponding to the specified VLAN name
802.3 organizationally specific TLV
MAC/PHY Configuration/Status TLV