Ruijie RG-S2600G-I Series - Page 332

CLI ReferenceInterface Configuration Commands QinQ Configuration Commands
Parameter
description
Parameter
Description
no
Remove the settings.
Default
configuration
No uplink port is configured.
Command
mode
Interface configuration mode.
Examples
Here is an example of configuring the interface as a uplink port.
Ruijie(config)# interface gigabitEthernet 0/1
Ruijie(config-if)# switchport mode up-link
Ruijie(config)# end
Related
commands
Command
Description
show vlan
Platform
description
The software version must be RGOS10.1 and later.
switchport dot1q-tunnel allowed vlan
Use this command to configure the allowed VLAN of dot1q-tunnel.
switchport dot1q-tunnel allowed vlan [add] {tagged|untagged} v_list
switchport dot1q-tunnel allowed vlan remove v_list
no switchport dot1q-tunnel allowed vlan
Parameter
description
Parameter
Description
add
Add the allowed vlan.
tagged
Tag-carried.
untagged
Not tag-carried.
v_list
vlan id list.
no
Remove the settings.
Default
configuration
Allowed vlan 1,untagged.
Command
mode
Interface configuration mode.