Ruijie RG-S2600G-I Series - Page 331

CLI ReferenceInterface Configuration Commands QinQ Configuration Commands
Related
commands
Command
Description
show interface
mac-address-mapping
x
Platform
description
The software version is RGOS10.4 and later.
switchport mode dot1q-tunnel
Use this command to configure the interface as the dot1q-tunnel interface.
switchport mode dot1q-tunnel
no switchport mode
Parameter
description
Parameter
Description
no
Delete the corresponding dot1q-tunnel
interface configuration.
Default
configuration
No dot1q-tunnel interface is configured.
Command
mode
Interface configuration mode.
Examples
Here is an example of configuring the interface as the dot1q-tunnel
interface:
Ruijie(config)# interface gi 0/1
Ruijie(config-if)# switchport access vlan 22
Ruijie(config-if)# switchport mode dot1q-tunnel
Ruijie(config)# end
Related
commands
Command
Description
show vlan
Platform
description
The software version must be RGOS10.1 and later.
switchport mode uplink
Use this command to configure the interface as an uplink port.
switchport mode uplink
no switchport mode