CLI Reference IP Address Configuration Commands
The following configuration sets 1000 trusted ARPs.
arp trusted 1000
Enable the trusted ARP function.
This command is not supported by routers.
Use this command to set trusted ARP aging. The no form of this command restores the
default value.
GSN trusted ARP is not aging by default.
Global configuration mode.
Use this command to set trusted ARP aging. Aging time is the same as dynamic ARP aging
time. Use the arp timeout command to set aging time in interface mode.
Enable trusted ARP function.
This command is not supported by routers.
Use this command to configure the maximum number of the unresolved ARP entries. The no
form of this command can restore the default value of 8192.
To Next Page
Loading...
Need help?
General