Ruijie RG-S2600G-I Series - Page 393

CLI Reference IPv6 Configuration Commands
If no parameter is specified, the default parameters will be used, and the prefix cannot be used for
auto address configuration.
Related
Commands
Command
Description
show ipv6 interface
Show the RA information of an interface.
Platform
Description
N/A
ipv6 nd ra-hoplimit
Use this command to set the hopcount of the RA message. Use the no form of this command to
restore it to the default setting.
ipv6 nd ra-hoplimit value
no ipv6 nd ra-hoplimit
Parameter
Description
Parameter
Description
value
Hopcount
Defaults
The default value is 64.
Command
Mode
Interface configuration mode.
Usage Guide
It is used to set the hopcount of the RA message.
Configuration
Examples
Ruijie(config -if)# ipv6 nd ra-hoplimit 110
Related
Commands
Command
Description
show ipv6 interface
Show the interface information.
ipv6 nd ra-lifetime
Set the lifetime of the device.
ipv6 nd ra-interval
Set the interval of sending the RA message.
ipv6 nd ra-mtu
Set the MTU of the RA message.
Platform
Description
N/A
ipv6 nd ra-interval
Use this command to set the interval of sending the RA. Use the no form of this command to restore it