Ruijie RG-S2600G-I Series - Page 404

CLI Reference IPv6 Configuration Commands
ra-info
Show the RA information of the interface.
Defaults
N/A v
Command
Mode
Privileged EXEC mode.
Usage Guide
Use this command to show the address configuration, ND configuration and other information of an
IPv6 interface.
Configuration
Examples
Ruijie# show ipv6 interface vlan 1
Interface vlan 1 is Up, ifindex: 2001
address(es):
Mac Address: 00:00:00:00:00:01
INET6: fe80::200:ff:fe00:1 , subnet is fe80::/64
Joined group address(es):
ff01:1::1
ff02:1::1
ff02:1::2
ff02:1::1:ff00:1
INET6: 2001::1 , subnet is 2001::/64 [TENTATIVE]
Joined group address(es):
ff01:1::1
ff02:1::1
ff02:1::2
ff02:1::1:ff00:1
MTU is 1500 bytes
ICMP error messages limited to one every 10 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds<240--160>
ND device advertisements live for 1800 seconds
The following line is included in the above information: 2001::1, subnet is 2001::/64 [TENTATIVE].
The flag bit in the [ ] following the INET6 address is explained as follows:
Flag
Meaning
ANYCAST
Indicate that the address is an anycast address.
TENTATIVE
Indicate that the DAD is underway. The address
is a tentative before the DAD is completed.
DUPLICATED
Indicate that a duplicate address exists.