CLI Reference IPv6 Configuration Commands
Indicate that the preferred lifetime of the
address expires.
Indicate that no DAD is implemented for the
address.
Indicate that the interface ID of the address is
automatically generated by the system, which is
usually an EUI-64 ID.
Ruijie# show ipv6 interface vlan 1 ra-info
vlan 1: DOWN
RA timer is stopped
waits: 0, initcount: 3
statistics: RA(out/in/inconsistent): 4/0/0, RS(input): 0
Link-layer address: 00:00:00:00:00:01
Physical MTU: 1500
ND device advertisements live for 1800 seconds
ND device advertisements are sent every 200 seconds<240--160>
Flags: !M!O, Adv MTU: 1500
ND advertised reachable time is 0 milliseconds
ND advertised retransmit time is 0 milliseconds
ND advertised CurHopLimit is 64
Prefixes: (total: 1)
fec0:1:1:1::/64(Def,Auto,vltime: 2592000, pltime: 604800, flags: LA)
Description of the fields in ra-info:
Indicate whether the RA timer is started.
Indicate that the RS is received but the number
of the responses is not available.
Indicate the number of the RAs when the RA
timer is restarted.
out: Indicate the number of the RAs that are
sent.
In: Indicate the number of the RAs that are
received.
inconsistent: Indicate the number of the
received RAs in which the parameters are
different from those contained in the RAs
advertised by the device.
Indicate the number of the RSs that are
received.
Link-layer address of the interface.
To Next Page
Loading...
Need help?
General