Ruijie RG-S2600G-I Series User Manual

CLI Reference IPv6 Configuration Commands
Parameter
Description
Parameter
Description
value
TTL value
Defaults
The default value is 128.
Command
Mode
Interface configuration mode.
Usage Guide
This command is used to specify the TTL value of the IPv4 header in the encapsulated IPv6
messages.
Configuration
Examples
Ruijie(config)# interface tunnel 1
Ruijie(config-if)# tunnel ttl 64
Related
Commands
Command
Description
tunnel mode
Configure the mode of a tunnel.
tunnel source
Configure the source IP address of the tunnel.
tunnel destination
Configure the destination IP address of a
tunnel.
Platform
Description
N/A
tunnel vrf
Use this command to configure the VRF to which the outer-layer addresses of a tunnel belong. The
VRF routing table is used to forward packets to the tunnel interface.
tunnel vrf vrf-name
no tunnel vrf
Parameter
Description
Parameter
Description
vrf-name
Name of the tunnel out-layer VRF.
Defaults
The outer-layer source and destination addresses of a tunnel are global addresses.
Command
Mode
Interface configuration mode.
Usage Guide
The outer-layer source and destination addresses of a tunnel must be in a VRF. If the specified VRF
does not include a route to the destination address, the tunnel interface is down.

Ruijie RG-S2600G-I Series Specifications

General

Brand	Ruijie
Model	RG-S2600G-I Series
Category	Switch
Language	English