Ruijie RG-S2600G-I Series - Page 420

CLI Reference IPv6 Configuration Commands
Configuration
Examples
Example 1: Specify the outer-layer VRF of a manually IPv6 over IPv4 tunnel as IPv4 VRF red.
Ruijie(config)# ip vrf red
Ruijie(config-vrf)#exit
Ruijie(config)# interface tunnel 1
Ruijie(config-tunnel1)# tunnel mode ipv6ip
Ruijie(config-tunnel1)# tunnel vrf red
Related
Commands
Command
Description
tunnel mode
Configure the mode of a tunnel.
ip vrf
Configure an IPv4 VRF.
tunnel source
Configure the source IP address of the tunnel.
tunnel destination
Configure the destination IP address of a
tunnel.
Platform
Description
Supported on the routers only.