CLI Reference IP Routing Configuration Commands
ip static route-limit number
no ip static route-limit number
Upeer threshold of static routes, ranging from
1 to 32.
Global configuration mode.
The goal is to control the number of static routes.
The S2600-I series products support up to 32 IPv4 static
routes.
The following example sets the upper threshold of the static routes to
10 and then restores the setting to the default value.
ip static route-limit 10
no ip static route-limit
ipv6 route
Use this command to configure an ipv6 static route. Use the no form of this command to delete the
configured route.
ipv6 route ipv6-prefix / prefix-length { ipv6-address | interface [ ipv6-address ] } [ distance ]
IPv6 prefix, which must comply with
the IP address form defined in
RFC4291.
To Next Page
Loading...
