CLI Reference IP Routing Configuration Commands
ipv6 static route-limit
Use this command to set the upper threshold of the static route. Use the no form of this command to
restore the setting to the default value.
Ipv6 static route-limit number
no ipv6 static route-limit number
Upper threshold of static routes in the range
of 1 to 16.
Global configuration mode.
The goal is to control the number of static routes.
The S2600-I series products support up to 16 IPv6 static
routes.
The following example sets the upper threshold of the ipv6 static
routes to 10 and then restores the setting to the default value.
Ruijie# ipv6 static route-limit 10
Ruijie# no ipv6 static route-limit
Configure the IPv6 static route.