Ruijie RG-S2600G-I Series - Page 521

CLI Reference IP Routing Configuration Commands
ipv6 unicast-routing
Use this command to enable the IPv6 route function of the RGOS. Use the no form of this command to
disable this function.
ipv6 unicast-routing
no ipv6 unicast-routing
Parameter
description
None
Default
configuration
Enabled
Command
mode
Global configuration mode
Usage
guidelines
The IPv6 static route takes no effect if the IPv6 routing function is
disabled.
The S2600-I series products support only the IPv4 or IPv6 static
routes, and IPv4 or IPv6 directly connected route.
Configure the static route to obtain the IPv4 or IPv6 static route.
Configure the IP address of the SVI to obtain the IPv4 or IPv6
directly connected route.
Examples
The example disables the IPv6 route function of RGOS
Ruijie# no ipv6 unicast-routing
Related
commands
Command
Description
ipv6 route
Configure the IPv6 static
route
show ipv6 route
Show the IPv6 routing
table