Ruijie RG-S2600G-I Series - Page 525

CLI Reference IP Routing Configuration Commands
Usage
guidelines
This command can show route information flexibly.
Examples
The following is the output of this command:
Ruijie(config)# show ipv6 route
IPv6 routing table name is Default(0) global scope - 7
entries
Codes: C - Connected, L - Local, S - Static, R - RIP, B
- BGP
I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS
summary
O - OSPF intra area, OI - OSPF inter area, OE1 - OSPF
external type 1, OE2 - OSPF external type 2
ON1 - OSPF NSSA external type 1, ON2 - OSPF NSSA external
type 2
[*] - NOT in hardware forwarding table
L ::1/128 via Loopback, local host
C 10::/64 via Loopback 1, directly connected
L 10::1/128 via Loopback 1, local host
S 20::/64 [20/0] via 10::4, Loopback 1
L FE80::/10 via ::1, Null0
C FE80::/64 via Loopback 1, directly connected
L FE80::2D0:F8FF:FE22:33AB/128 via Loopback 1, local
host
Field
Description
O
Source routing protocol,
which may be:
C: directly connected route
S: static route
R: RIP route
B: BGP route
O: OSPF route
I: IS-IS route