CLI Reference IGMP Snooping Configuration Commands
Global configuration mode.
The profile must be applied to the specified interface in order to make
the profile take effect.
The following is an example of creating a profile numbered 1 and
entering the profile configuration mode.
Ruijie(config)# ip igmp profile 1
Ruijie(config-profile)#
Configure the multicast address
range.
ip igmp snooping dyn-mr-aging-time
To configure the aging time of the routing interface that the switch learns dynamically, execute the ip
igmp snooping dyn-mr-aging-time command .
ip igmp snooping dyn-mr-aging-time time
no ip igmp snooping dyn-mr-aging-time
Aging time of the routing interface that
the switch learns dynamically, within the
range from 1 to 3600 seconds.
Global configuration mode.
When the dynamic routing interface learning function is enabled, this
command sets the aging time of the routing interface. If the aging
time is set too short, the routes may be added and deleted frequently.
Set the aging time of the routing interface that the switch learns
dynamically to 100 s:
Ruijie(config)# ip igmp snooping dyn-mr-aging-time 100
To Next Page
Loading...
Need help?
General