Ruijie RG-S2600G-I Series - Page 530

CLI Reference IGMP Snooping Configuration Commands
Related
commands
Command
Function
-
-
ip igmp snooping fast-leave enable
To enable the fast leave function, execute the ip igmp snooping fast-leave enable command in the
global configuration mode. The no form of this command is used to disable the function.
ip igmp snooping fast-leave enable
no ip igmp snooping fast-leave enable
Parameter
description
Parameter
Description
N/A
Default
configuration
Disabled.
Command
mode
Global configuration mode.
Usage
guidelines
After you execute this command to enable the fast-leave function, the
system will remove the corresponding multicast group on the
corresponding interface upon the receipt of the IGMP leave message.
Examples
The following example shows how to enable the fast leave function
on the switch:
Ruijie(config)# ip igmp snooping fast-leave
Related
commands
Command
Function
N/A
ip igmp snooping filter
To configure a port to receive a specific set of multicast streams, execute the ip igmp snooping filter
command in the interface configuration mode to associate the port to a specific profile. The no form of
this command is used to delete the associated profile.
ip igmp snooping filter profile-number
no ip igmp snooping filter profile-number
Parameter
description
Parameter
Description
profile-number
Profile number, within the range from 1 to
1024.