CLI Reference IGMP Snooping Configuration Commands
Global configuration mode, interface configuration mode.
With IGMP Profile applied on a port, if the IGMP Report message is
received on this port, the device will check whether the multicast
address which this port to be added is within the IGMP Profile
permitted range. If yes, this port will be added and processed then.
A specific profile must be created before association.
The following example demonstrates how to associate profile 1 to a
megabit port 0/1:
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if)# ip igmp snooping filter 1
ip igmp snooping host-aging-time
To configure the aging time for the IGMP dynamic member port, execute the ip igmp snooping
host-aging-time command in global configuration mode. The no form of this command is used to
restore the default value.
ip igmp snooping host-aging-time seconds
no ip igmp snooping host-aging-time
Aging time, in the range of 1 to 65535. The unit
is second.
Global configuration mode.
The following example sets the aging time of the IGMP dynamic port
To Next Page
Loading...
Need help?
General