CLI Reference IGMP Snooping Configuration Commands
ip igmp snooping preview interval
Use this command to configure the interval that allows the user to preview the specific
multicast streams when the user doesn't have access to such multicast streams. Use no form
of this command to restore the preview interval to the default value.
ip igmp snooping preview interval num
no ip igmp snooping preview interval
Preview interval (1-300);
default: 60 seconds.
The default value is 60 seconds.
Global configuration mode.
The following example sets the multicast preview
interval as 100 seconds on the 100M port of 0/1:
Ruijie(config)# ip igmp snooping preview interval
100
Enable the multicast
preview.
This command is supported after release 10.4(3).
ip igmp snooping querier
To enable the IGMP querier function, execute "ip igmp snooping querier" global
configuration command. Use no form of this command to disable IGMP querier in all VLANs
and disable the global configurations.
ip igmp snooping querier
no ip igmp snooping querier
To Next Page
Loading...
Need help?
General