CLI Reference Guide HTTP Service Configuration Commands
The default port number is 443.
Global configuration mode
You can use this command to set HTTPS service's port.
The following example sets HTTPS service's port number as 4443.
Ruijie#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#ip http secure-port 4443
enable service web-server
Enables the HTTP service.
Shows the web server status.
Use this command to show Web service configuration information and status.
The following example shows the Web service configuration information and status.
Ruijie#show web-server status
http server status : enabled
http server port : 80
https server status: enabled
https server port: 443
http(s) use memory block: 768, create task num: 0
To Next Page
Loading...
Need help?
General