CLI Reference Guide HTTP Service Configuration Commands
enable service web-server
Enables the HTTP service.
Sets HTTP service's port.
Sets HTTPS service's port.
Use this command to set Web login verification username and password. Use the no form of the
command to restore the default configuration.
webmaster level privilege-level username name password { password | [ 0 | 7 ]
encrypted-password }
no webmaster level privilege-level [ username name ]
Bond user authority level
Encryption type, 0 means no encryption, while 7 means
simple encryption
Global configuration mode
To use the HTTP service, you need to pass the login verification to enter the Web page. You can use
the command to set the username and password for the verification.
Use the no webmaster level privilege-level command to delete all usernames and passwords with
the specified authority level.
Use the no webmaster level privilege-level username name command to delete specified username
and password.
Username and password have three authority levels; each authority level can configure
20 usernames and passwords at most.
The following example configures the username and password for the Web login verification.
Ruijie#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.