Ruijie RG-S2600G-I Series - Page 565

CLI Reference MLD Snooping Configuration Commands
Default
Settings
The default profile action is deny.
Command
mode
Profile configuration mode.
Usage
guidelines
Before configuring this command, use the range
command to set the multicast range first.
Examples
The following example shows how to prevent the multicast flow profile
within the range of FF77::100 from being forwarded:
Ruijie(config)# ipv6 mld profile 1
Ruijie(config-profile)# range FF77::100
Ruijie(config-profile)# deny
Related
commands
Command
Description
ipv6 mld profile
Create one profile.
range
Set the multicast address range.
permit
Set the profile action permit.
permit
Use this command to allow the multicast flow profile within the specified range in the profile configuration
mode.
permit
Parameter
description
Parameter
Description
-
-
Default
Settings
The default profile action is deny.
Command
mode
Profile configuration mode.
Usage
guidelines
Before configuring this command, use the range
command to set the multicast range first.
Examples
The following example shows how to allow the multicast flow profile
within the range of FF77::1 to be forwarded only:
Ruijie(config)# ipv6 mld profile 1