Ruijie RG-S2600G-I Series - Page 568

CLI Reference MLD Snooping Configuration Commands
ipv6 mld snooping svgl profile
Use this command to specify the group address range to be in the SVGL mode. Use the no form of this
command to cancel this association.
ipv6 mld snooping svgl profile profile-number
no ipv6 mld snooping svgl profile
Parameter
description
Parameter
Description
profile-number
Set the profile number. The valid
range is 1-1024.
Default
Settings
No profiles are associated with svgl by default.
Command
mode
Global configuration mode.
Usage
guidelines
With the SVGL mode or IVGL-SVGL mode configured for
the MLD Snooping working mode, a profile shall be
associated with the IVGL for the purpose of specifying the
group address range in the SVGL mode. That is to say,
the member port of the multicast forwarding entry can be
forwarded across the VLANs, while the member ports of
the corresponding multicast forwarding entries within other
multicast address range must belong to the same VLAN.
By default, no profile is associated, which means that
apply no multicast group in the SVGL mode.
Examples
The following example shows how to specify the SVGL mode
application range as the profie1 group address range:
Ruijie(config)# ipv6 mld snooping svgl profile 1
Related
commands
Command
Description
ipv6 mld
snooping ivgl
Enable the mld snooping and set
the ivgl mode.
ipv6 mld
snooping
ivgl-svgl
Enable the mld snooping and set
the ivgl-svgl mode.
ipv6 mld snooping ivgl-svgl
Use this command to enable the mld snooping and specify the ivgl-svgl mode in the global configuration
mode. Use the no form of this command to disable this function.
ipv6 mld snooping ivgl-svgl profile-number