Ruijie RG-S2600G-I Series - Page 569

CLI Reference MLD Snooping Configuration Commands
no ipv6 mld snooping ivgl-svgl
Parameter
description
Parameter
Description
profile-number
Set the profile number. The valid
range is 1-1024.
Default
Settings
Disabled.
Command
mode
Global configuration mode.
Usage
guidelines
IVGL-SVGL mode: the IVGL mode and the SVGL mode
co-exist. Use the MLD Profile to allocate a batch of
multicast address range to the SVGL, within which the
member port of the multicast forwarding entry can be
forwarded across the VLANs, while the member ports of
the corresponding multicast forwarding entries within other
multicast address range must belong to the same VLAN.
Examples
The following example shows how to enable the mld snooping and
set the ivgl-svgl mode(the specified profile1 group address belongs to
the SVGL application range):
Ruijie(config)# ipv6 mld snooping ivgl-svgl
Ruijie(config)# ipv6 mld snooping svgl profile 1
Related
commands
Command
Description
ipv6 mld
snooping ivgl
Enable the mld snooping and set
the ivgl mode.
ipv6 mld
snooping
ivgl-svgl
Enable the mld snooping and set
the ivgl-svgl mode.
ipv6 mld snooping dyn-mr-aging-time
Use this command to set the aging time of the dynamic multicast route port. Use the no form of this
command to restore it to the default value.
ipv6 mld snooping dyn-mr-aging-time time
no ipv6 mld snooping dyn-mr-aging-time
Parameter
description
Parameter
Description
time
Set the aging time of the dynamic
multicast route port, in seconds. The