CLI Reference MLD Snooping Configuration Commands
Layer-2 multicast device enables the aging timer of all
member ports in this specific group. The time of the timer
is the longest response value. When the timer value
decreases to 0, it indicates that there is no member
receiving the multicast flow on the interface, and the
Layer-2 device removes this interface from the MLD
Snooping forwarding list.
For the source query packets of the MLD specific group,
the timer is not updated.
The following example shows how to set the maximum response time
of the MLD general query packet as 15s:
Ruijie(config)# ipv6 mld snooping query-max-response-time 15
ipv6 mld snooping vlan
Use this command to enable the mld snooping function for the specified vlan. Use the no form of this
command to disable this function.
ipv6 mld snooping vlan vid
no ipv6 mld snooping vlan vid
The vlan id number. The valid range is
1-4094
By default, the mld snooping is enabled in all VLANs.
Global configuration mode.
By default, the mld snooping is enabled in all VLANs. You
can disable the mld snooping for the specified vlan.
The following example shows how to disable the mld snooping
function in vlan1:
Ruijie(config)# no ipv6 mld snooping vlan 1
ipv6 mld snooping vlan mrouter learn
Use this command to enable the switch to dynamically learn MLD query or PIM packets to identify the
mrouter interface automatically. Use the no form of this command to restore it to cancel the dynamic
learning.
ipv6 mld snooping vlan vid mrouter learn
To Next Page
Loading...
