Ruijie RG-S2600G-I Series - Page 572

CLI Reference MLD Snooping Configuration Commands
no ipv6 mld snooping vlan vid mrouter learn
Parameter
description
Parameter
Description
vid
The vlan id, with the valid range
1-4094.
Default
Settings
Disabled.
Command
mode
Global configuration mode.
Usage
guidelines
The mrouter interface is the interface of the multicast
device connected with the peer device. By default, the
dynamically-learned mroute interface is enabled on the
layer-2 multicast device. Use the no option to disable this
function and clear all dynamically-learned mroute
interfaces. With the source port check enabled, only the
multicast flow through the mroute interface are valid and
forwarded to the registered interface on the layer-2
multicast device. Those multicast flow through the
non-mroute interface are invalid and will be discarded.
With the source port check function enabled, use the
dynamically-learned mroute interfaces to improve the mld
snooping flexibility.
Examples
The following example shows how to enable the dynamic multicast
route port learn function:
Ruijie(config)# ipv6 mld snooping vlan 1 mrouter learn
Related
commands
Command
Description
ipv6 mld
snooping vlan
mrouter interface
Set the mrouter interface.
ipv6 mld snooping vlan mrouter interface
Use this command to set the static mrouter interface. Use the no form of this command to delete a static
mrouter interface.
ipv6 mld snooping vlan vid mrouter interface interface-id
no ipv6 mld snooping vlan vid mrouter interface interface-id
Parameter
description
Parameter
Description
vid
The vlan id, with the valid range