Ruijie RG-S2600G-I Series - Page 573

CLI Reference MLD Snooping Configuration Commands
1-4094.
Interface-id
The interface number.
Default
Settings
N/A.
Command
mode
Global configuration mode.
Usage
guidelines
Use this command to set the static mrouter interface for
the purpose that all IPv6 multicast data received on the
switch can be forwarded. With the source port check
function enabled, only the multicast flow through the
mroute interface can be forwarded.
Examples
The following example shows how to set a multicast routing port:
Ruijie(config)# ipv6 mld snooping vlan 1 mrouter interface
fastEthernet 0/1
Related
commands
Command
Description
ipv6 mld
snooping
source-check
port
Set the multicast source port
check.
ipv6 mld snooping vlan static interface
Use this command to set a static member port to receive the multicast flow for the purpose of preventing
the port from being influenced by the MLD Report packets with the MLD Snooping enabled. Use the no
form of this command to delete a static member port.
ipv6 mld snooping vlan vid static ipv6-multiaddr interface interface-id
no ipv6 mld snooping vlan vid static ipv6-multiaddr interface interface-id
Parameter
description
Parameter
Description
vid
The vlan id, with the valid range
1-4094.
ipv6-multiaddr
The multicast address.
interface-id
The interface number.
Default
Settings
N/A.