CLI Reference RADIUS Configuration Commands
that the security sever does not respond.
The following example sets the number of retransmissions to 4:
Ruijie(config)# radius-server retransmit 4
Define the RADIUS security server.
Define a shared password for the RADIUS
server.
Define the timeout for the RADIUS packet.
radius-server timeout
Use this command to set the time for the device to wait for a response from the security server after
retransmitting the RADIUS packet. The no format of this command is used to restore it to the default
setting.
radius-server timeout seconds
no radius-server timeout
Timeout in the range 1 to1000 seconds.
Global configuration mode.
Use this command to change the timeout of packet retransmission.
The following example sets the timeout to 10 seconds:
Ruijie(config)# radius-server timeout 10
Define the RADIUS security server.
Define the number of the RADIUS
To Next Page
Loading...
Need help?
General