CLI Reference GSN Configuration Commands
You shall configure an appropriate authentication name of the
appropriate protocol version according to the server settings, when it
is necessary to configure the communication between the switch and
the server. If you choose v3, use the snmp-server command to set
the v3 username. For the detailed information, please refer to SNMP
command reference.
The following example shows how to set the v1
community:
Ruijie(config)# security v1 community public
The following example shows how to set the v3 username
to start:
Ruijie(config)# security v3 user start
security event interval
Use this command to set the minimum interval of security event. Use the no form of this command to
restore it to the default value.
security event inteval interval
no security event inteval
Configure the security event interval.
Global configuration mode.
Use the show security event interval to view the configuration.
Ruijie# security event interval 10
show security
event interval
View the minimum interval of security event.
To Next Page
Loading...
