CLI Reference ND Snooping Configuration Commands
ND Snooping Configuration Commands
ipv6 nd snooping
Use this command to enable the IPv6 ND Snooping function in global configuration mode. Use the no
form of this command to disable this function.
Global configuration mode.
The following example shows how to enable the IPv6 ND Snooping function:
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# ipv6 nd snooping
Show the ipv6 nd snooping configurations.
Use this command to set the trust port. Use the no form of this command to set the untrust port.
no ipv6 nd snooping trust
To Next Page
Loading...
Need help?
General