CLI Reference ND Snooping Configuration Commands
The port is untrusted by default.
Interface configuration mode.
The following example shows how to set the interface FastEthernet 0/1 as the Trust port:
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# interface fastethernet 0/1
Ruijie(config-if)# ipv6 nd snooping trust
Show the ipv6 nd snooping configurations.
Use this command to show the IPv6 nd snooping static configurations.
show ipv6 nd snooping [ interface ]
Show the related interface configurations only.
The following example shows the IPv6 nd snooping static configurations:
Ruijie# show ipv6 mld snooping
To Next Page
Loading...
Need help?
General