Ruijie RG-S2600G-I Series - Page 800

CLI Reference NFPP Configuration Commands
NFPP Configuration Commands
cpu-protect sub-interface {manage | protocol | route} pps
Use this command to configure the traffic bandwidth of each type of packets.
cpu-protect sub-interface {manage | protocol | route} pps pps_vaule
Parameter
description
Parameter
Description
pps_value
The rate limit threshold, ranging from 1 to 8192
Default
The default traffic bandwidths of each type of packets are:
Manage packets: 3000pps;
Route packets: 3000pps;
Protocol packets: 3000pps.
Command
mode
Global configuration mode.
Examples
Ruijie(config)# cpu-protect sub-interface manage pps 200
Related
commands
Command
Description
cpu-protect
sub-interface
{manage |
protocol |
route} percent
Configure the percent value of each
type of packets occupied in the buffer
area.
cpu-protect sub-interface {manage | protocol | route} percent
Use this command to configure the percent value of each type of packets occupied in the buffer area.
cpu-protect sub-interface {manage | protocol | route} percent percent_vaule
Parameter
description
Parameter
Description
percent_value
The percent value, ranging from 1 to
100.