CLI Reference NFPP Configuration Commands
The default percent values of each type of packets occupied in the
buffer area are:
Manage packets: 30;
Route packets: 20;
Protocol packets: 45.
Global configuration mode.
Ruijie(config)# cpu-protect sub-interface manage
percent 60
cpu-protect
sub-interface
{manage |
protocol |
route} pps
Configure the traffic bandwidth of
each type of packets.
arp-guard attack-threshold
Use this command to set the global attack threshold. When the packet rate exceeds the attack threshold,
the attack occurs.
arp-guard attack-threshold {per-src-ip | per-src-mac | per-port} pps
Set the attack threshold for each
source IP address.
Set the attack threshold for each
source MAC address.
Set the attack threshold for each port.
Set the attack threshold, in pps. The
valid range is [1,9999].
By default, the attack threshold for each source IP address and
source MAC address is 8pps; and the attack threshold for each port is
200pps.
To Next Page
Loading...
